Find A Electrician

Blog Electrical Q&A?

What Are The Requirements Around The Location Of An Electrical Panel?

Answer : Think about your favourite refrigerator the volume of space that would be needed by a refrigerator is about how much working clearance you need in front of an electrical panel. Here are the basics for a dwelling; both access to the working space and the actual working space is required. The depth of the workspace is 36 inches. This depth must meet or exceed the width of the panel, or the length of the panel, whichever is greater. If each side of the panel can be offset against the edge of the workspace, the panel need not be centred on the workspace. But, the width of the working space must allow for the panel door to open at least 90 degrees. The height of the working space must be  6-1/2 feet.

Other electrical equipment located above or below the panel cannot protrude more than 6-inches beyond the front of the panel. The space equal to the width and depth of the panel extending from the floor to the structural ceiling is dedicated to electrical equipment; that means no plumbing or gas pipes, no ductwork, or any other foreign equipment. The clearances are put in place for the sake of the individual working on the panel. It’s hard without your arms being unrestrained to safely perform your work on the panel.

Also, panels need to be readily accessible, meaning the area should not be used as storage space, be located over the steps of a stairway, or require a ladder for access. Because they operate much slower than conventional electrical wiring systems, they cannot normally be installed in spaces with very flammable substances, such as clothing closets or bathrooms. They are not recommended to be installed anywhere near easily ignitable material, such as in clothing closets, as the moisture may cause substantial corrosion problems.

Can An Electrical Panel Be Installed In A Bathroom?

Answer : No Do Not Install An Electrical Panel In A Bathroom.

Surveyors and technicians should identify all the electrical components, wires, lights, and so on that are to be utilized in a particular environment. (indoor dry locations, indoor or outdoor wet locations, hazardous [explosive] location inside a vehicle paint spray booth, etc.). The rules are to be followed whenever necessary, so electrical equipment and electrical lines may not be installed in damp or wet locations, in areas around gases, fumes, vapours, liquids, volatile or deteriorating agents, and locations exposed to extreme temperatures.

Electrical conductors and equipment that are rated for dry, indoor locations free of any corrosive effects obviously would be the most economical to purchase. Do they make equipment for corrosive locations, such as inside your favourite drive-through car wash? Yes, but it’s going to be much more expensive. Contemplate streamlining every device’s installation and connecting them in a way that prevents damage, and then cut down on the variety of electrical cables that are connected to the store using the worst locations.

Is Burying Dead Wires Safe?

Question: Is it ok to leave a dead wire buried in the wall, when it’s almost impossible to remove

Answer: Yes.

If there is any sort of raceway, including rigid or flexible metal or non-metallic cable, those abandoned, discontinued, or disconnected wires should be eliminated. For cable-type wiring methods, abandoned cables that are accessible and are not terminated at a piece of equipment or tagged for future use should be removed. Whenever there is no alternative access to the cables, you have to think practically. Both ends must be cut and disconnected so the cables cannot be used again or will inadvertently charge, which may quickly generate a fire or cause loss of life in extreme circumstances.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *